INTO THE FIREPLACE
The Clarity Fireplace Insert has an integrated draft hood, so a separate draft hood is not re- quired.
Some fireplace openings may be large enough to connect the draft hood to the venting after the unit has been moved to its final position. Some openings will be too small and will require that the draft hood first be connected to the venting, and then guided into position on the top of the insert as the unit is pushed back into the fireplace.
Particularly in installations with tight clearances, the procedure will be most easily accomplished if the trim and wing panels are installed as the last step.
Follow these steps:
1.Connect the Clarity Insert's detachable draft hood to the end of the venting by sliding it inside the venting, then secure it with three sheet metal screws.
2.Line up the two draft hood guides with the
Clamps |
Guides |
Nuts |
fourth heat exchanger tube in on each side on the back of the stove as shown above.
3.With assistance, push the insert back into the fireplace, while at the same time pulling on the draft hood to coax it into position. Continue until both guides are far enough forward that the retainer clamps and nuts can be installed on the threaded guide bolts.
4.Tighten the nuts to secure the draft hood.
5.Adjust the rear levelling bolts until the unit is level.
6.Install the wing panels; they attach to brackets on each side of the Clarity. Install the side wing
10
panels first, using two
Install the top wing panel last using two
Before tightening, make sure the outer edges of the top panel align with the edge of the side pan- els.
Brass edge trim is added as the last step of install- ing the wing panels.
7.Mount the side trim
Install the left side trim panel first by placing the bottom close to where it goes, then align the top and move it close to the insert body until it is held snugly by the two magnets.
The right side trim panel installs in the same fashion as the left, but the wiring (Two Amp Mate-
Move the right panel close enough to make the connection. Align the three wire male connector with the latch to the bottom. Push into the three wire female connector on the stove until it clicks.
Do the same with the two wire connector with the latch turned to the top. move panel into place while routing the switch wires into the opening of the wing bracket. Secure the panel.
AIR SHUTTER ADJUSTMENT
The final step of the installation is to check the flame pattern, which should resemble the pattern illustrated in the right column.
The flames should be relatively
Start the fire according to the directions on page 11 and allow the heater to burn for approximately 15 minutes. The flames will increase in length and become more yellow in color as the unit heats up.
Three adjustment