Harman Stove Company 828i manual Assembly, Removing the Glass door, Removing and Replacing logs

Assembly

The Clarity 828I Fireplace Insert comes with the log set packed inside the firebox. The three trim panels and two wing brackets are packed together in a separate carton. NOTE: The wing brackets must go on before the door.

Left Wing

Bracket

Right Wing

Bracket

A second shipping carton contains the wing panels. Two different size wing panel sets are available for the Clarity Insert: large (32-1/2" X 44"), and small (30" X 40"). The set that will work best with the fireplace opening should be used. The wing panels may be trimmed to fit inside the fireplace opening if a flush look is desired.

Before the unit is installed, all components should be unpacked. The cross log must be re- moved, the packing material taken out, and then re-installed.

The Clarity 828I is shipped from the factory equipped to burn either natural gas or propane. If the alternate fuel is to be used, the appropriate burner system module must be installed at this time as well. See the fuel conversion instructions in Appendix A on page 15.

Removing the Glass door

NOTE: The glass door is heavy. Be prepared for its weight when lifting it to avoid damage during removal.

Locate latches on each side of the glass door. Then, grasp each latch handle and pull forward until the front is disengaged. Lift the glass door

7

slightly and remove it	Latch
from the stove. Set the
glass door aside in a
safe place where it
will not be damaged.
WARNING: Do not
abuse the glass on the
Clarity Fireplace
Insert front by strik-
ing, slamming, or
similar trauma. Do
not operate this
Fireplace Insert with
the glass panel re-
moved, cracked or
broken. Use only glass
supplied by Harman and approved for use with
this heater. Do not use substitute materials. Re-
placement of the panel should be done by a li-
censed or qualified service person.

Removing and Replacing logs

The log set consists of a back log (1), a center log that has a pilot-viewing port in the left end (2), ember strip (3), and a cross log that rests on top

(4).

4

1

2

3

Remove the cross log, the center log, and the ember strips, in that order. To remove the rear log, first pull the fuel system module forward about an inch to create clearance, then lift the log out.

Re-install the logs in the same order that they were removed. Place the rear log in position first, centered and pushed snugly against the back wall, and slide the fuel system module back into posi- tion.

Re-install the ember strips so that they rest against the front of the firebox. Guide them to- ward you and to the outside until they fit snugly. Check the air slot in the inside of the ember strips to confirm that they do not obstruct it.