Operating Your Printer 2

Printing Transparencies and Adhesive Labels

1. Pull out the rear exit extender until it locks

2. Lift out the support bar.

3. Insert the label sheet with print-side up.

Guidelines for Transparencies and Labels

Always use manual feed.

Always use rear output when printing transparencies and adhesive labels.

Should be specifically made for laser printers or photocopiers.

Must be able to withstand heat of 200°C for 0.1 second.

Labels should cover the entire carrier sheet–carrier and adhesive must not be exposed to any part of the printer.

Use rear paper output – to reduce heat exposure and curling.

Using Recycled Print Media

Recycled paper should be restricted to 20% to 35% Post Consumer Content and not exceed 50%. Paper must be relatively stiff and have minimum edge curl. Paper should be white and bright for maximum contrast. The surface should be smooth, clean, and stable electrically and dimensionally.

Recycled paper used by OKIDATA printers must be specifically denoted by the paper manufacturer to be for laser printers, or laser guaranteed or compatible. Using media outside these specifications may cause

problems requiring service that will not be covered by OKIDATA warranty or service agreements.

The following recycled paper has been tested and approved for use in OKIDATA printers.

Weyerhaeuser, Lynx Opaque, 20% PCW, 20lb., 28 lb. and Laser Copy, 20 lb.

Union Camp Great White (Laser), 25% PCW, 20lb., 24lb.

International Paper, Beckett Division, Enhanced Marble, 50% Recycled, 20% PCW, 24lb.

International Paper, Hammermill Division, Savings DP, 20% PCW, 20 lb.

Georgia Pacific, GeoCycle, 20% PCW, 20lb.

James River, WordPro Laser, 20% PCW, 20lb., 24lb.

Warren, SpectraTech, Gloss and Matte, 10% PCW, 28lb., 32lb.

Cross Pointe, Worx, 50% Recycled, 20% PCW

Strathmore, Script Bright White Wove, 50% Recycled

28

OKIPAGE 10i User’s Guide

Page 38
Image 38
Oki PAGE 10I manual Printing Transparencies and Adhesive Labels, Using Recycled Print Media