4 Problem Solving

Maintenance Menu Mode

MESSAGE: USER MNT

Explanation: Maintenance Menu has been accessed.

Action: Press MENU button to see categories.

MESSAGE: MENU RESET

Explanation: Menu reset option has been accessed.

Action: Press ENTER to reset Menus 1 & 2 to factory settings, or press MENU to see next category.

MESSAGE: HEX DUMP

Explanation: Hex Dump option has been accessed.

Action: Press ENTER to start hex dump of received data, or MENU for next category. Power OFF/ ON to exit hex dump mode.

MESSAGE: DRUM CNT RESET

Explanation: Drum Counter Reset option has been accessed.

Action: Press ENTER to reset drum counter, or press MENU for next category.

MESSAGE: OP MENU

Explanation: Control panel Enable/ Disable category accessed. Change to Disable to deactivate control panel; features can be controlled only through software. To reset, enter Maintenance Menu.

Action: Press NEXT + to toggle enable/disable then press

ENTER.

Cleaning/Maintenance

MESSAGE: xxxxx

TONER LOW

Explanation: Toner is running out. Another message can display on the first line.

Action: Replace toner cartridge when print quality deteriorates.

MESSAGE: TONER SNS

Explanation: A fault occurred in the toner sensor; image drum car tridge is not properly installed.

Action: Install/reinstall image drum cartridge. If not cleared, contact Service.

MESSAGE: xxxxx

CHG DRUM

Explanation: Drum near end of life. Another message can display on the first line.

Action: Normal operations continue. Replace Image Drum Cartridge when print quality deteriorates.

MESSAGE: xxxxx

FUSER

Explanation: Fuser near end of life. Another message can display on the first line.

Action: Normal operations continue. When print quality deterio rates, contact service to replace fuser.

MESSAGE: COVER

Explanation: Cover is open.

Action:

Close cover.

OKIPAGE 10i User’s Guide

35

Page 45
Image 45
Oki PAGE 10I manual Maintenance Menu Mode, Cleaning/Maintenance, Message, Action