Olympus 150 operation manual Editing Messages, Overwrite Recording

T572InstDS-150-E.Q33J1999/4/260:57PM y [ W 26

EDITING MESSAGES

1. OVERWRITE RECORDING

When the REC button is pressed in the middle of a message while in the Stop mode or in the Playback-Pause mode, overwrite recording starts from that point.

XOverwrite recording is possible only within a single message.

XOverwrite recording can be continued for an extended period as long as sufficient memory remains.

3. PARTIAL ERASURE

3

ERASE SP DICT

MENU

INDEX/

FOLDER

4

ERASE SP DICT

MENU

INDEX/

FOLDER

5

ERASE SP DICT

MENU

INDEX/

FOLDER

2. INSERT RECORDING

REC STOP

REC STOP

REC STOP

3

ERASE SP DICT

MENU

INDEX/

FOLDER

REC STOP

4

ERASE SP DICT

MENU

INDEX/

FOLDER

REC STOP

5

ERASE SP DICT

MENU

INDEX/

FOLDER

REC STOP

1Stop playback at the start of the section you want to erase.

2In the Stop mode, press the MENU switch once (for less than 2 seconds) to display the menu on the LCD panel (the first menu displayed is the R-TIME setting menu).

3Press the Up/Down control on the MENU switch to display the Partial Erasure menu ([ERSE]) is shown on the LCD panel together with the current position.

4Press the MENU switch to start playback. Press the MENU switch again at the point where you want to stop erasing. (The Partial Erasure display starts blinking.)

5Within 4 seconds, press and hold the ERASE button for more than 1 second. The selected part of the message is erased and [OK] appears on the LCD. The Stop mode is restored.

XThe Partial Erasure mode is canceled when a button other than the ERASE button is pressed or if

1Stop playback at the point you want to insert a recording.

2In the Stop mode, press the MENU switch once (for less than 2 seconds) to display the menu on the LCD panel (the first menu displayed is the R-TIME setting menu).

3Press the Up/Down control on the MENU switch to display the Recording Mode menu ([MODE] is shown on the LCD panel). The LCD panel should also show the current status ([OVER-W] or [INSERT]).

4Pressing the MENU switch within 4 seconds allows you to switch between [OVER-W] (overwrite recording mode) and [INSERT] (insert recording mode). The Insert Recording mode starts when the STOP button is pressed or when no operation is performed for 4 seconds while [INSERT] is displayed.

5Make the recording.

6Press the STOP button to end insert recording.

XInsert recording is possible only once after mode setting. The insert recording mode is canceled as soon as any other operation (playback, etc.) is started after mode setting. To use insert recording again, repeat steps 1 to 6.

XInsert recording is not possible if there is no memory remaining.

the ERASE button is not pressed within 4 seconds after the Partial Erasure display starts blinking.

26 27