Installing Batteries

This recorder can be used with AAA Alkaline Batteries.

1

Lightly press down on the battery cover

release button, then open the battery

1

cover.

 

InstallingBatteries

 

2

Insert two AAA batteries, observing the

correct polarity as shown in the

illustration below, then close the battery cover.

Insert the batteries in the direction inscribed on the inside of the recorder’s battery compartment. In addition, when inserting the batteries, insert them so that the tape is under the batteries, as shown in the illustration. The batteries can then be removed easily by pulling up the tape. When pulling on the tape the batteries may suddenly pop out, so be sure to press down lightly on the batteries with your finger while pulling.

Recharging Battery Pack

The battery indicator on the display changes as the batteries lose power.

→ →

When appears on the display, replace the batteries as soon as possible.

When the batteries are too weak, the recorder

shuts down and [ Battery Low ] appears on the display.

Cautions Concerning the Battery

Warning

•Using batteries for which part or all of the external coating (insulating sheath) is peeling off or batteries which have ruptured may cause fluid leaks, overheating, and explosions. For this reason such batteries should absolutely not be used.

•Commercially available batteries for which part or all of the external coating (insulation sheath) has been peeled off should absolutely not be used.

Unusable batteries

Batteries for which the entire external coating (insulating sheath) is peeled off (naked batteries), or those where it has partially been peeled off.

12