Omega Engineering DP3600 user manual Mounting, Panel Cutout Dimensions

MOUNTING

1.Cut a hole in panel to the specifications shown in the figure 4:

1

A

2 3

4

B

3

3.62" (91.9mm)

1.70"

43.2mm

NOT DRAWN TO SCALE

Figure 4. Panel Cutout Dimensions

2.Insert pannel meter into the hole until it is flush with the pannel.

3.Refer to Figure 5. Losen the wing nuts (3) on the two screws (2) on the bracket. You don't have to remove the screws.

4.Slide the open end (A) of the bracket onto the meter until it is flush with the panel. The rear of the meter should touch the back of the bracket (B).

Figure - 5. Mounting Bracket Assembly

5.Tighten the wing nuts. Check that the meter is secure against the panel. If not, use a screwdriver and slip it into the slot between the bracket and the meter (refer to Figure 6 below to locate the spot where the screwdriver should go) and push the meter back with the screwdriver to reduce the gap between the meter and the panel. This will insure a tight fit for the panel meter.

Figure - 6. Screwdriver Placement -- Side view of mounting bracket

Bracket

Back of

the Meter

Screw Driver

Push Meter this way with the Screwdriver

18