SPECIFICATIONS
(typical @ 25 C and rated supply voltage unless otherwise specified).
STANDARD INPUT:
* 4 - 20 MA, 10 - 50 MA, 0 - 5 VDC, 0 - 10 VDC
EXTERNAL HOLD:
* An external low level signal applied to the HOLD pin on the rear connector will initiate hold function.
ANALOG TO DIGITAL CONVERSION:
*41/2 Digit A/D conversion.
*Dual slope integrating converter.
*Conversion Rate: seven conversions per second typical.
INPUT IMPEDANCE
* 100 OHMS for
POWER REQUIREMENTS (choice of three supply ranges):
*120 VAC
*240 VAC
*7.5 VDC
DIMENSIONS:
*Case: 3.60" x 1.75" x 7"
*Bezel size: 4.40" x 2.25" x 0.45"
*Extruded Aluminum enclosure
DISPLAY:
*Red
*Negative Polarity indication.
*Over range indication: HELP.
*Display Test: Briefly displays 8888 on power up.
RELAYS (optional):
* Single pole double throw, 1 Ampere @ 28VDC or 0.5 amp @ 120VAC, resistive.
OPEN COLLECTOR:
* Open collector drive: 5vdc @ 50ma each (maximum of six outputs)
SCALING:
* Programmable from
OFFSET:
* Programmable from
TARE:
∙Programmable and is equal to the value of programmed scale.
3
