2.3 Parts of the iServer Unit
iServer | iServer Reset Button |
RJ45 interface | iServer LEDs |
Side or Bottom |
|
| ACTIVITY |
|
| NETWORK LINK | |
|
| DIAGNOSTICS | |
Wire Entry for |
|
| |
8 | 1 | AND STATUS | |
Relay Connector | ETHERNET | RESET | |
| |||
Removable Plug |
|
| 16 Digit |
Connector for Relays |
|
| |
|
| LCD Display | |
under the Cover |
|
| |
|
|
| |
6
1
Flash
Memory
Card
Flash
Memory
Card
Reset
Button
UNITS TIME STBY BKLT
BAROMETER/TEMPERATURE
Probe
Handle
Clip
Mounting
Tabs
Buttons
DB9 | dc Power Input |
Connector |
|
Figure 2.3 Parts of the iServer Unit
Table 2.1 Parts of iServer Unit
ETHERNET RJ45 interface for
iServer RESET Button: Used for power reseting the iServer board (Ethernet connection).
FLASH RESET Button: Used for power reseting the Flash Memory Card/LCD board.
ACTIVITY LED (Red) Blinking: Indicates network activities (receiving or sending packets).
NET LINK LED (Green) Solid: Indicates good network link.
DIAGNOSTICS LED (Yellow) Blinking: Indicates transmitting data from iServer to flash memory card. When DHCP enabled, it remains solid until DHCP IP address is received.
LED (Green) Blinking: Indicates receiving data by the iServer from flash memory card
UNITS Button: Change display units of measurement from °C to °F
TIME Button: Change display from DATE and TIME to Pressure and Temperature
STBY Button: Will stop the Flash from recording.
BKLT Button: Display Back Light
When using the small push buttons, hold the button until “WAIT” is displayed on the LCD and then release.
5
