2.4 Disassembly Instruction

You may need to open the unit for one of the following reasons:

To wire relay connector. (Refer to Figure 2.7)

To connect or replace the battery.

To change S5 jumper. In the absence of AC power, and if S5 is installed, the LCD Backlight and iServer Board will be on and running on the battery power. Refer to Section 2.7.

Disconnect the power supply before proceeding.

Remove Cover as shown.

COVER

FLASH

CARD

MOUNTING

SCREWS (2)

RELAY

CONNECTOR

FLASH RESET

SWITCH

S5 (WITH LONG PINS)

JTAG

S5

TRAY

KEEP INSULATOR

COVER ON BATTERY

CLIP WHEN BATTERY

IS NOT BEING USED

REMOVE BATTERY CLIP INSULATOR COVER AND STORE WHERE SHOWN WHEN 9V BATTERY IS BEING USED.

Figure 2.4 Opening the Unit

6

Page 10
Image 10
Omega Engineering i.BTX-M manual Disassembly Instruction, Opening the Unit