6.4 Typical temperature reading sequence
Once all parameters have been set, the following sequence should normally be followed to extract temperature information from your FOB100 thermometer. 2 procedures can be used for this purpose. The first method consists in using the “ta” command (preferred), while the second sequence would be:
a)The host computer should send the “t” (or “t[i]”) command, followed by a E character.
b)The thermometer responds by echoing the requested temperature values, as indicated above; the transmission is terminated by a “*” character.
c)When the “*” character is received, it is suggested to immediately terminate the dialog session by having the host computer issue the “r” command followed by a E character.
21
