Omega Vehicle Security TJ-USB manual USB Driver Installation

Software 3

3.3 USB Driver Installation

To install the USB software drivers that are required for your TJ-USB probe to operate correctly follow these procedures.

NOTE:

You need to have the User Software CD that was supplied with your probe loaded into the CD drive on your PC.

1.Connect your TJ-USB probe to your computer. You should get a notice box that indicates that your computer “Has Found New Hardware”

2.Your computer will then launch the Found New Hardware Wizard. Follow the instructions indicated on the Wizard boxes and the additional instructions noted in this manual with each box.

NOTE:

After completing the Found New Hardware Wizard your system will ask that you repeat this process. This is normal. You should repeat the steps outlined here twice. After the second driver is installed you should then get the “New Hardware Ready For Use” notice.

Figure 9. Welcome To The Found New Hardware Wizard Screen

From this box you should check the “No, not at this time” button. Then click the “Next >” button to continue with the driver installation process.

3-5