Omnimount AB2 HTS Installation of wall plate continued, Step, Set screw location, Screw covers

Step 3	Installation of wall plate (continued)		Step 4	Installation of speaker plate onto speaker
Mounting to solid wood or wood studs.			1. Bose® speakers with 4MM or 5MM inserts.
Drill a pilot hole into center of each location using 3/32" drill bit (provided),
Drill 1-1/4'' into stud. Attach the plate with two #12 x 1-3/4" wood screws.
		fig. 3
��� ���	fig. 2
				� �
	��� ���	fig. 6	2. Speakers with single factory installed threaded insert.
		� � � �� �� � � � � �
fig. 4
wall	� � ��	wall

� �

� �

Step 5 Installation of adjusting knuckle and extension.

3.Speakers with 2 installed 1/4''-20 or 6MM x 15MM threaded inserts.

�

	�
�	Set screw location
Screw covers	1/4''-20 x 5/8'' or
	6MM x 15MM	�
	(not supplied)
Set screw locations

Extension		4. Speakers with a single keyhole in back.
	Set screw location	Insert into keyhole and slide upward then tighten.

5. Speakers without mounting holes - wood cabinet only.

	#12 x 3/4''	� �� �	�
	3/32'' drill bit
OmniMount Systems, Inc.	100% Replacement Warranty
The Pointe at South Mountain
	Audio Basics products are engineered and manufactured to the highest� standards. In the event that there are defects in materials,	Copyright 2004 OmniMount Systems, Inc.
8201 South 48th Street
	workmanship, or missing parts, OmniMount Systems will, at its discretion, repair or replace your Audio Basics product. Claims that	All rights reserved. OmniMount products
Phoenix, Arizona 85044-5355	are submitted must include either the sales slip or proof of purchase.	are covered by patents issued and/or
	If OmniMount products are used for purposes other than their original intent, OmniMount Systems, its distributors and retailers shall
		pending. “OmniMount” is a registered
Toll free 1-800-MOUNT-IT	not be held responsible or liable for injuries or property damage, direct, indirect or consequential, which may arise from the inability
		trademark of OmniMount Systems, Inc.
(480) 829-8000	to use this product safely, properly, and in the manner for which it has been designed and manufactured.
	This warranty does not apply to products which have been lost, damaged by misuse, abuse or accident, altered or repaired in any	"Audio Basics" is a trademark of
Fax: (480)756-9000	way other than specified by OmniMount Systems, Inc.	OmniMount Systems, Inc.
email: info@omnimount.com	This warranty is non-transferable.	AB-2 revision 2, 1/04 Part #1000254.
	For installation assistance please call our toll free help line at 1-800-MOUNT-IT