oSet the month
If the month is not correct:
•press the up button 
to increase the month
•press the down button 
to decrease the month
Once the month is correct, press the set button again
oSet the time
If the time is not correct:
•press the up button 
to increase the hours and minutes
•press the down button 
to decrease the hours and minutes
Once the time is correct, press the Start/Stop button
¾Place the user selection switch to User A.
¾Follow the instructions in the manual pages 26 ‐ 29 on applying the arm cuff
¾Take a measurement with your blood pressure monitor
oPress the Start/Stop button.
oThe arm cuff will start to inflate automatically taking a measurement.
oWhen the measurement is complete, blood pressure and pulse rate are displayed.
Step 2: Get ready to use your blood pressure monitor with HealthVault™
¾If HealthVault Connection Center is not running on your computer, please start it and sign in to your account. Connection Center then will open to a screen showing your device(s).
¾Select the Omron Blood Pressure device picture on the left hand side of Connection Center.
¾If you do not see a picture of your device in Connection Center, select Set up a new device and follow the on‐screen instructions.
Step 3: Connect your Omron 10 Series +™ Blood Pressure Monitor to your computer and upload your reading to HealthVault™
¾Press the Start/Stop button to turn the monitor off.
¾Find the USB cable that came with your blood pressure monitor.
¾Plug the small end of your USB cable into the slot on your blood pressure monitor that's marked with the USB symbol.
¾Plug the large end of your USB cable into your computer.
¾The symbol “□” will start circling on the blood pressure monitor display when it is successfully connected to the computer. After several seconds the blood pressure display will be blank.
NOTE: If the USB cable was connected when you took the last measurement, please disconnect and connect the cable again. Also, do not unplug the USB connector until the data has finished uploading.
2
