B.“Trim-out” steps:
1.The Cat 5e cable that was run from the triple gang plastic box to the enclosure should be pulled out of the box and terminated with an
NOTE: Use proper tools and standard TIA 568A rules to prep and terminate the Cat 5e cable, such as the
Figure 7
Figure 8
2.It should then be plugged into the “INPUT” connector on the rear of the WAP Assembly as shown in Figure 8.
3.The
| Figure 9 |
|
|
|
|
301 Fulling Mill Road, Suite G | ©Copyright 2005 by | |
Middletown, PA 17057 | www.onqlegrand.com | |
|
| |
Page 6
