On-Q/Legrand 1307877 owner manual Click OK twice to exit and save your settings

6.Ensure the box next to Internet Protocol (TCP/IP) is selected (see Figure 27).

NOTE: Although this series of steps is used to re-configure the PC from direct WAP configuration back to its previous use as a DHCP controlled PC on the Router network, they can also be used to configure the WAP Network Interface Card for DHCP control by selecting the WAP NIC at the top of this screen.

7.Click to highlight Internet Protocol (TCP/IP) and click the Properties button to go to the Internet Protocol (TCP/IP) Properties screen.

(For Windows 98SE or ME, from the Network Window’s configuration tab, select the TCP/IP line the for the appropriate Ethernet adapter and Click Properties. From the TCP/IP Properties Window, Click on the IP Address tab.)

Figure 28

8.Select Obtain an IP address automatically (see Figure 28).

9.Click OK twice to exit and save your settings.

(For Windows 98SE, ME, or 2000 you will have to restart the computer to save these settings).

10.After the reboot (if appropriate), your PC should be now be ready for operation as before, directly through the Router, or through the WAP (if a Wireless NIC card was installed).

301 Fulling Mill Road, Suite G	©Copyright 2005 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA 17057	www.onqlegrand.com
(800)-321-2343

Page 18