On-Q/Legrand 1307877 Connection Area Detailed Description, Status Indicators Detailed Description

2.Connection Area Detailed Description

INPUT – This RJ-45 connector is where the Cat 5e cable from the Power Over Cat 5e Inserter Module in the On-Q Enclosure plugs in. There is an Extractor Module in the WAP Assembly that breaks out the required DC power from the data on the input Cat 5e cable connection.

NOTE: Notice in Figure 2 that there is also a small factory installed jumper cable that supplies the required DC power and data to the WAP assembly.

3.WAP Assembly Status Indications (P/N 364891-01 shown)

Figure 3 shows the WAP 802.11g Assembly status indicators, which are visible when the WAP cover is properly installed:

Data

Figure 3

Wireless

Power

4.Status Indicators Detailed Description:

Data Indicator

ON (Blue) – The device is connected to a data network.

OFF – The device is powered off or not connected to a data network.

Wireless Indicator

ON (Blue) – The device is on and operating normally. OFF – The device is powered off.

Blinking (Blue) – The device is transmitting or receiving data.

Power Indicator

ON (Blue) - The device is powered on and operating normally. OFF – The device is powered off or performing a boot sequence. Blinking (Blue) Firmware upgrade failed.

5.WAP 802.11g Reset Button Access

Figure 4 shows the WAP 802.11g with the cover removed to gain access to the Reset Button. As shown, there is a tab that when pushed in the direction shown will activate the Reset Button. Pushing and holding this tab for five seconds or more will return the unit to

301 Fulling Mill Road, Suite G	©Copyright 2005 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA 17057	www.onqlegrand.com
(800)-321-2343

Page 3