One for All URC-6131 manual Searching for Your Code, LED will blink twice

OFA 6 PVR 2/15/03 9:25 AM Page 11

5.If you’ve located a setup code that works, but it also has a separate VCR code, you’ll also need to program it into the remote control to access VCR controls as follows:

a. Press VCR once. Then press and hold the SET key until the LED blinks twice.

b.Enter the VCR code for your DVD Player/VCR Combo. If correct, the LED will blink twice.

NOTE: If a separate VCR setup code is not listed, you can use the VCR key to program a separate VCR device or another device (see “Re-Assigning Device Keys”on page 15)

6.For future reference, write down the working DVD Player/VCR combo code in the below boxes:

DVD/VCR Code:

VCR Code: (if used)

SEARCHING FOR YOUR CODE

If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed at all, try searching for your code. For example, to search for a code for your TV:

1. On the remote control, press TV once.

2. Press and hold SET until the LED (red light)

blinks twice, then release SET.

3. Enter 9 - 9 - 1. The LED will blink twice.

4. Aim the remote control at the the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off.

NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first.

5.	To lock in the code, press and release SET.
	The LED will blink twice.

6.To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate device key for the device you are searching for.

11