One for All URC-6131 manual Operating Master Power, Clearing Master Power

OFA 6 PVR 2/15/03 9:25 AM Page 13

2. Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.

3. For the first device you want in the power on sequence, press its device key (e.g., CBL/SAT) once.

4.Repeat step 3 up to five more times to add desired devices to the power-on sequence.

5. To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET.

Operating Master Power

1. After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on or off your devices.

NOTE: When POWER is pressed for less than

2 seconds, a power command will only be sent to the currently-selected device. This allows you to still individually power devices on or off.

2.You will see the devices turn on or off according to your programmed sequence.

NOTE: The currently-selected device will always turn on first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device.

NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). This action is normal.

Clearing Master Power

1. Press and hold SET until the LED (red light)

blinks twice, then release SET.

2. Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.

3. Press and hold SET until the LED blinks twice, then release SET. Master Power is now cleared.

13