OFA 6 PVR 2/15/03 9:25 AM Page 14
USING KEYMOVER
The One For All
NOTE: The following keys cannot be used as a source or
destination: TV, PVR, DVD, CBL/SAT, AUD, VCR, and SET.
Programming Keymover
For example, if your VCR does not have volume control, you can map those keys (i.e., VOL+,
1. Press and hold SET until the LED (red light)
blinks twice, then release SET.
2. Enter 9 - 9 - 4. The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL+ once.
5. For the destination mode, press VCR once.
6. For the destination key, press VOL+ once.
7.The LED will blink twice indicating the keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to map remaining volume control keys, substituting VOL- and Mute as source and destination keys in steps 4 and 6.
Upon completion of the above procedure, you can now use your One For All
Restoring Keymoved Keys to Default Settings
Restoring A Single Keymoved Key
1.Press a device key that has a keymoved key.
2. Press and hold SET until the LED (red light)
blinks twice, then release SET.
3. Enter 9 - 9 - 4. The LED will blink twice.
4.Press the destination key twice (where the keymoved key is stored). The LED will blink twice.
14