One for All URC-6131 manual Checking the Codes, Programming Master Power

OFA 6 PVR 2/15/03 9:25 AM Page 12

CHECKING THE CODES

If you have set up the remote control using the Searching For Your Code procedure (on the previous page), you may need to find out which four-digit code is operating your equipment.

For example,to find out which code is operating your TV:

1. On the remote control, press TV once.

2. Press and hold SET until the LED (red light)

blinks twice, then release SET.

3. Enter 9 - 9 - 0. The LED will blink twice.

4. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e.g., three blinks = 3) and write down the number in the leftmost box in the TV code boxes on page 10

NOTE: If a code digit is “0”, the LED will not blink.

5. Repeat step 4 three more times for

remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Write down the code digits in the remaining TV code boxes on page 10.

6.To check for codes of other devices, repeat steps 1 through 5, but substitute the appropriate device key for each device you are checking. Write down the device’s code digits in the appropriate code boxes on page 10.

PROGRAMMING MASTER POWER

In its default state, the POWER key on the URC-6131 remote control will individually power your home entertainment devices on or off. However, you can also program a Master Power function onto the POWER key that will sequentially turn on or off all the devices with a single key press.

Programming The Power Key For Master Power

1. Press and hold SET until the LED (red light)

blinks twice, then release SET.

12