Device Sleeptimer
If your TV or Satellite has a “Sleeptimer” function built in, you can access this function with your ONE FOR ALL remote. To do so:
1Make sure your TV (or Satellite) is switched on.
2Press the device key (TV or SAT).
3Point the ONE FOR ALL at your TV (or Satellite) and press and release MAGIC then press POWER. You should see the Sleeptimer activate on your TV screen.
To increase the timer, simply press MAGIC then POWER again until the timer gets to the desired time.
To deactivate the Sleeptimer, repeat steps
Important note: Depending on how you used sleeptimer on the original remote, you might need to access sleeptimer in a different way (through menu for example).
The ONE FOR ALL Sleeptimer
If your device does not have a sleeptimer function built in, you can install the ONE FOR ALL sleeptimer function. To do so:
1Press the device key (TV or SAT).
2Then, press and hold MAGIC until the red light blinks twice.
3Press 9 7 0. The red light will blink twice again. It is only necessary to perform steps 1, 2 and 3 once. Now to set the timer, continue with the steps below.
Setting the ONE FOR ALL Sleeptimer:
It is possible to set the timer for 15, 30, 45 or 60 minutes. To do this, first make sure your TV (or Satellite) is switched on.
Press the device key (TV or SAT).
(:15)
(:30)
(:45)
(:60)
Now, press and release MAGIC, then press POWER.
The red light will blink once which indicates the timer is set for 15 minutes. To increase the timer, simply press POWER again (this must be done within 5 seconds). The red light will blink twice indicating the timer is set for 30 minutes (2x 15). You can press POWER to a maximum of four times which will set the timer to 60 minutes.
Once you have set the timer to the desired time, set your ONE FOR ALL remote down, pointing it at your device. When the programmed amount of time has elapsed, the ONE FOR ALL will send the command for POWER, hence turning off your device.
Important notes:
-The red light on the ONE FOR ALL will blink every 15 seconds indicating that the remote is in Sleeptimer mode.
-To deactivate the Sleeptimer, simply press any key on the ONE FOR ALL remote.
-Also, it is only necessary to follow steps 1,2 and 3 above once. For subse- quent use of the Sleeptimer, simply begin with “Setting the ONE FOR ALL Sleeptimer”.
-To switch the ONE FOR ALL back to Device Sleeptimer, repeat steps 1,2 and 3 above. The red light will blink 4 times.
-Remember, when using the ONE FOR ALL Sleeptimer, you must set the remote so it is pointing to your device.
-The ONE FOR ALL Sleeptimer can be set up for only one device at a time.
10 | WWW.ONEFORALL.COM |
