36 • microFlash Configurat ion User Manual and Technical Gui de The O'Nei l microFlash Series of Printers
Transmit
Transmit allows you to send the current configuration to the printer. Be
sure you have connected your download cable to the COM port specified
in your setup. Then click on this button.
This will not update your firmware. See “Updating the microFlash” at the
end of this chapter to update firmware.
There will be a pause, then the printer will beep (provided the beeper is
turned on). The computer will then download the configuration
information to the microFlash. This will take just a few minutes, and the
transmit status will appear on your computer screenPrint out a self test by
pressing and holding the microFlash’s red self test button for four
seconds. The self test will verify that your parameters are set to your
specifications.
Note: You cannot download your current configuration to the same
COM-Port that is in use by IrDA or any other device (e.g. an internal
card for Fax/modem or games).