User Manual and Technical Gui de The O'Nei l microFlash Series of Printers Paper Loading • 43
through the center of the paper roll. Place the narrow end of the rod into
the small hole on the side of the paper cavity. Snap the wider end into the
cutout on the opposite side of the paper cavity. Turn the paper knob
clockwise to tighten the paper slack in the cavity. Replace the end boot
and tear off extra paper.
Automatic Paper Loading MF2t/2tcr/2I/2icr/4t/4tcr
With the loose, clean edge of the paper coming from the bottom of the
roll, insert the edge of the paper between the roller and the platen. Press
the red self test button to wake the printer. Push the button again while
the printer is awake causes the mechanism to feed about 1” of paper.
Insert the paper into the paper well with it resting on the paper rod clips.
Press the red button while the printer is on and it will feed paper. You
will need about 2 inches of paper comming out of the mechanism. Now
lower the cover while placing the extra paper though the tearbar. Latch
cover closed and tear off extra paper.
Manual Paper Loading MF2/3/4t/4tcr
Lift up the paper release lever. This takes the pressure off the platen.
Make sur e you have a cl ean ed ge on the new pap er rol l. Next ta ke the
edge of the paper and fold it 45 degrees. Insert the tip of the paper
between the roller and the platen. Push on the paper until the tip is
peeking out the other side. (If it seems too tight to insert the tip,
disengage the paper release lever and turn the feed knob.) Now grab the
tip and pull it through until the paper is straight. Push down the paper
lever. Insert the plastic paper rod through the center of the paper roll.
Place the narrow end of the rod into the small hole on the side of the
paper cavity. Snap the wider end into the cutout on the opposite side of
the paper cavity. Turn the paper knob clockwise to tighten the paper
slack in the cavity. Replace the end boot and tear off extra paper.
Manual Paper Loading MF2t/2tcr/4t/4tcr
Lift up the paper release lever. This takes the pressure off the platen.
Make sur e you have a cl ean ed ge on the new pap er rol l. Next ta ke the
edge of the paper and fold it 45 degrees. Insert the tip of the paper
between the roller and the platen. Push on the paper until the tip is
peeking out the other side. (If it seems too tight to insert the tip,
disengage the paper release lever and turn the gear to advance the paper.)
Now grab the tip and pull it through until the paper is straight. Push
down the paper lever. Insert the paper into the paper well with it resting
in the paper rod clips. Press the red button while the printer is on and it
will feed paper. You will need about 2 inches of paper comming out of
the mechanism. Now lower the cover while placing the extra paper
though the tearbar. Latch Cover closed and tear off extra paper.
F
old