Onkyo A-9755, 9555 instruction manual Troubleshooting-Continued, Recording, Others

Troubleshooting—Continued

Recording

Can’t record.

•The component connected to the MAIN IN jacks cannot be recorded.

•When using the A-9755 as a power amplifier (MAIN IN function), recording is not possible.

Others

The Volume control has no effect.

•When using the A-9755 as a power amplifier (MAIN IN function), the Volume control has no effect. Adjust the volume on the connected preamp instead.

The Muting function doesn’t work.

•When using the A-9755 as a power amplifier (MAIN IN function), the Muting function does not work. Use the muting function on the connected preamp instead.

The A-9755/A-9555 contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lock up. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least ten seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.

How to reset:

To reset the A-9755/A-9555 to its factory defaults, while holding down the [PURE DIRECT] button, press the [LOUDNESS] button, and then release both buttons. The input selector indicators light up for one second, and then the A-9755/A-9555 enters On mode.

A-9755/A-9555 BLOCK DIAGRAM

	SELECTOR
	VOLUME
PHONO	ON
CD
TUNER	OFF
	BASS,
IN	TREBLE
TAPE	PURE DIRECT
OUT
IN
MD
OUT	ON
HDD IN
LINE	OFF
	BASS, TREBLE

	HEADPHONE
	DIGITAL
MAIN IN	AMPLIFIER
	ON
	OFF	LOW PASS
	L-ch
		FILTER
POWER
AMP		SPEAKER B
DIRECT		RELAY
MAIN IN	R-ch	LOW PASS
		FILTER
	ON
	OFF

	DIGITAL
A-9755 ONLY	AMPLIFIER

SPEAKER A RELAY

SPEAKER SPEAKER

AB

19