Onkyo 9555 Using the MAIN IN Function A-9755only, Recording, Enjoying Audio Sources-Continued

Enjoying Audio Sources—Continued

Using the MAIN IN Function (A-9755 only)

You can use the A-9755 as power amplifier with a sepa- rate preamp. See page 13 for connection information.

POWER AMP DIRECT (MAIN IN)

1	Press the [POWER AMP DIRECT
	(MAIN IN)] button for 3 seconds
	until the MAIN IN indicator lights up.
	The MAIN IN function comes on and
	the MAIN IN indicator lights up.
	While the MAIN IN function is on,
	only audio from components con-
	nected to the preamp can be output.
	To turn the MAIN IN function off,
	press the [POWER AMP DIRECT
	(MAIN IN)] button for 3 seconds until
	the MAIN IN indicator goes off.

Notes:

•Do not connect a component that does not have an output volume con- trol to the MAIN IN jacks and use the MAIN IN function, because the sound will be output at maximum volume and may damage the A-9755 and your speakers.

•While the MAIN IN function is on, the A-9755’s Volume control has no effect. Before you turn off the MAIN IN function, make sure that the Volume control is not turned up high, to prevent any loud surprises.

•While the MAIN IN function is on, the following A-9755 functions are disabled:

-Volume control

-Input selector

-Remote control operation

- function

-LOUDNESS control

-Recording

-Muting

Operate the connected preamp for some of these functions including controlling volume, selecting input, and muting. The [STANDBY] and [ON] buttons on the remote control- ler will work even when the MAIN IN function is on.

Recording

Unless you have the full consent of the copyright holder, copyright laws prohibit using your recordings for anything other than personal enjoyment!

Input selector

1	Use the input selector to select
	the component that you want to
	record from.

2	Prepare the recorder:
	• Set the recorder so that it’s ready for
	recording.
	• If necessary, adjust the recording
	level on the recorder.
	• See the recorder’s manual for more
	information.
3	Start playback on the component
	selected in step 1.
	Note:
	If you select another input source dur-
	ing recording, the newly selected input
	source will be recorded.

Notes:

•You can record on a recorder that’s connected to the MD OUT or TAPE OUT L/R jacks.

•The tone controls have no effect on the signal being recorded.

•When using the A-9755 as a power amplifier (MAIN IN function), recording is not possible.

17