Onkyo A-933 instruction manual 0 A B, Front & Rear Panels-Continued

*En_A933_02.fm Page 7 Tuesday, January 25, 2005 1:46 PM

Front & Rear Panels—Continued

Rear Panel

1 2 3 4 5 6 7 8 9

GND

L L

R R

PHONO (MM) TUNER

L L

SUBWOOFER

PREOUT

R	R
MAIN IN	OUT MD IN

0 A B

AGrounding terminal

	L
		B
	R
CD	LINE
	L
		R
	R	REMOTE
OUT	IN	CONTROL

TAPE/CDR

C

SPEAKERS

		A
		AC OUTLET
		AC 230-240V
L	R	L	50 Hz
		UNSWITCHED
		TOTAL 100W MAX.
		CAUTION: SPEAKER IMPEDANCE
INTEGRATED AMPLIFIER		A or B :	4 OHMS MIN. /SPEAKER
MODEL NOA. -933		A + B :	8 OHMS MIN. /SPEAKER

J SUBWOOFER PREOUT

This terminal is for connecting a turntable’s ground wire.

BPHONO (MM) input

This analog audio input is for connecting a turntable with a moving-magnet cartridge.

CTUNER input

This analog audio input is for connecting a tuner’s analog audio output.

DCD input

This analog audio input is for connecting a CD player’s analog audio output.

ELINE input

This analog audio input is for connecting a compo- nent’s analog audio output (TV, etc).

F REMOTE CONTROL jacks

These (Remote Interactive) jacks can be con-

nected to the jacks on your other Onkyo audio components. The A-933’s remote controller can then be used to control all of your components. To

use , you must make an analog audio connection between the A-933 and each component.

GSPEAKERS B

This jack is for connecting a powered subwoofer.

K MAIN IN

This analog audio input is for connecting a separate

preamp when you want to use the A-933 as a power

amplifier.

Caution:

Do not connect a component that does not have an

output volume control, such as a CD player, because

the sound will be output at maximum volume and

may damage the A-933 and your speakers.

L MD IN/OUT

This analog audio input and output are for connect-

ing an MD recorder with an analog audio input and

output.

M TAPE/CDR IN/OUT

This analog audio input and output are for connect-

ing a recorder (CD, cassette, etc) with an analog

audio input and output.

These terminal posts are for connecting speaker set

B.

HSPEAKERS A

These terminal posts are for connecting speaker set A.

IAC OUTLET

This AC outlet can be used to supply power to another audio component. The type of outlet depends on the country in which you purchased the A-933.

See pages 11–16 for connection information

7