Onkyo BD-SP808 Controlling AV Components that are Out of Range, Controlling Other Out-of-RangeAV Components

CONNECTIONS

Controlling AV Components that are Out of Range

You can use the following multi-room kits to control the BD-SP808 when it’s out of range of the remote controller:

•Multiroom kits such as those made by Niles and Xantech.

IR

IR

IN

IN

RS232

Controlling Other Out-of-Range AV Components

If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the BD-SP808's IR IN jack, as shown below.

Signal flow

	Connecting
	block
IR IN
IR OUT	BD-SP808
	IR emitter

Remote controller

Other component

Connect the IR emitter to the BD-SP808's IR OUT jack, and place the IR emitter in front of the other AV component's remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR emitter.

from	Other component
connecting block	Remote control
	sensor
Miniplug cable	IR emitter
Miniplug

IR

IN

BD-SP808

IR emitter

Signal flow

Only remote controller signals received by the BD-SP808's IR IN jack are fed through to the IR OUT jack. Signals picked up by the BD-SP808's remote control sensor are not output.

20 EN