FUNCTION SETUP

Network Connection

Set up the network connection settings in order to use BD- Live, DLNA home media server or network update function.

Connection Test

After you enable a network connection or change the network settings, always perform the connection test to check if the connection is correctly made.

1In stop mode, press [SETUP].

2Use [K / L] to select , then press [ENTER].

3Use [K / L] to select “Others”, then press [ENTER].

4Use [K / L] to select “Network Connection”, then press [ENTER].

5Use [K / L] to select “Connection Test”, then press

[ENTER].

Connection test will start automatically and the test result will appear right after the connection test finishes.

•“Testing...” : The test is in progress.

• “Pass”

: Connection test is successfully

 

completed.

•“Fail” : Connection test failed. Check the

connection settings.

Press [ENTER] to go to the list of network status confirmation screen.

Enable(Easy)

Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.)

- IP Address Setting

Auto(DHCP)

- DNS Setting

Auto(DHCP)

- Proxy Setting

Do Not Use

- Connection Speed

Auto

- BD-Live Setting

Allow

If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below.

1Follow steps 1 to 4 in “Connection Test” on page 51.

2Use [K / L] to select “Enable(Easy)”, then press [ENTER].

•The unit will start the connection test automatically and the test result will appear right after the test finishes.

•After the connection test finishes, press [ENTER] to go to network status confirmation screen.

3Press [ENTER] to activate the network settings and set the network connection automatically. Press [SETUP] to exit.

Note

•The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure.

Others

Connection Test

IP Address

xxx.xxx.xxx.xxx

Subnet Mask

xxx.xxx.xxx.xxx

Default Gateway

xxx.xxx.xxx.xxx

Primary DNS

xxx.xxx.xxx.xxx

Secondary DNS

xxx.xxx.xxx.xxx

then press ‘ENTER’.

 

6Press [ENTER] to go back to the previous screen, or press [SETUP] to exit.

Note

•If the connection test passes, you can enjoy the BD- Live, DLNA home media server feature or network update function, using the Internet without making any extra settings.

•If the connection test fails, you may need to change the MAC address settings of your router.

•“Connection Test” is not available when “Disable” is selected in “Network Connection”.

Enable(Custom)

In following cases, select “Enable(Custom)” to set each setting as necessary.

-When connection test failed with the setting of “Enable(Easy)”.

-When instructed by your Internet service provider to make specific settings in accordance with your network environment.

•IP Address Setting / DNS Setting

1Follow steps 1 to 4 in “Connection Test” on page 51.

2Use [K / L] to select “Enable(Custom)”, then press [ENTER].

3Use [K / L] to select “IP Address Setting”, then press [ENTER] repeatedly to select the desired setting.

“Auto(DHCP)” : If your router has DHCP server function, select “Auto(DHCP)”.

“Manual” : If your router does not have DHCP server function, select “Manual”.

EN

51