Before Using the Compact Disc Player
Installing the Batteries
1To open the battery compartment, press the small hollow and slide the cover.
Using the Remote Controller
To use the remote controller, point it at the compact disc player’s remote control sensor, as shown below.
Remote control sensor
Compact disc player
Installing the Compact Disc Player
20 cm (8")
10 cm (4")
2
3
Insert the two supplied batteries (R03/AAA) in accordance with the polarity diagram inside the battery compartment.
Replace the cover and slide it shut.
30° off center | Approx. 16 ft. (5 m) |
(Left/Right) |
|
Note
•The remote controller may not work reliably if the compact disc player is subjected to bright light, such as direct sunlight or
•If another remote controller of the same type is used in the same room, or the compact disc player is installed close to equipment that uses infrared rays, the remote controller may not work reliably.
•Don’t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries.
•The remote controller may not work reliably if the compact disc player is installed in a rack behind colored glass doors. Keep this in mind when installing.
•The remote controller will not work if there’s an obstacle between it and the compact disc player’s remote control sensor.
10 cm (4")
10 cm (4")
Install the compact disc player on a sturdy rack or shelf. Position it so that its weight is evenly dispersed on its four legs. Do not install the compact disc player in a place with vibration or an unstable location.
Note
• If the remote controller doesn’t work reliably, try replacing the batteries.
• Don’t mix new and old batteries or different types of batteries.
• If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.
• Remove expired batteries as soon as possible to prevent damage
En
from leakage or corrosion.
10