Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not covered in the table, please consult your nearest Onkyo authorized service center.
Symptom | Cause | Remedy |
S TA N D B Y / O N b u t t o n i s pressed, but power does not come on.
• Power cord plug is not properly con- • Insert the plug firmly. nected to AC outlet.
Disc is loaded in the disc tray, but playback will not begin.
•Disc is in the disc tray upside down.
•Disc is dirty.
•Moisture has accumulated inside the CD player.
•Load the disc with the label facing upward.
•Clean the disc.
•Remove the disc from the disc tray, place the CD player in a warm place and leave the power on for about one hour.
| • | You are playing an | • | Replace the disc. |
|
| corded |
|
|
|
|
|
|
|
No sound | • | Incomplete or incorrect connections. | • | Check all cable connections. (See |
|
|
|
| pages |
•Improper input selector switch setting on amplifier.
•Insert all plugs firmly into jacks.
•Set switch to proper position. See your amplifiers operating instructions for more information.
| Disc skipping | • | Disc is dirty. | • Clean the disc. (See page 19) | |
|
| • | Disc is scratched. | • | Replace the disc. |
|
| • | CD player has been bumped. | • | Place the CD player in a more stable |
|
|
|
|
| location. |
|
|
|
|
|
|
| Search time (when moving to | • | Disc is dirty. | • | Clean the disc. (See page 19) |
| a specific track) is extremely | • | Disc is scratched. | • | Replace the disc. |
| long. | ||||
|
|
|
|
| |
|
|
|
|
| |
| Track numbers cannot be | • | No disc in the tray. | • Load a disc into the tray. | |
| stored in the memory. | • | A track number not on the disc is | • | Use only the track numbers on the |
|
| ||||
|
|
| being input. |
| disc. |
|
|
|
|
| |
| Noise during play | • | Interference from TV | • Turn off the TV, or move the unit far- | |
|
|
|
|
| ther from the TV. |
|
|
|
|
|
|
| Remote controller does not | • | Battery level is low. | • | Replace the batteries. |
| function. | • Your position is too far from the unit’s | • Remote controller is possible within a | ||
|
| ||||
|
|
| distance of approximately 5 meters | ||
|
|
| remote control sensor or out of the |
| |
|
|
|
| from the unit’s sensor and a detection | |
|
|
| sensor’s detection angle. |
| |
|
|
|
| range of 30°. | |
|
|
|
|
| |
|
| • | An obstacle exists between you and | • | Operate from a different position or |
|
|
| the unit’s remote control sensor. |
| remove the obstacle. |
|
| • The system components are not con- | • | Connect the system components | |
|
|
| nected properly. |
| properly according to the |
|
|
|
|
| struction manual. |
|
| • | “DVD” has been selected as the in- | • Select “CD” as the input source. (Re- | |
|
|
| put source for |
| fer to the instruction manual for the |
20 |
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|