Onkyo CR-505DAB instruction manual Troubleshooting

Troubleshooting

If you have any trouble using your CR-505DAB, check the following table for possible causes and remedies. If you still can’t resolve the issue yourself, please contact your Onkyo dealer.

Trouble	Possible Cause	Remedy
Can’t turn on the CR-	The power cord is not connected properly.	Connect the power cord properly to a suitable
505DAB?		wall outlet (page 16).
		Check the speaker connections and make sure
	The speaker cables are not connected prop-	that none of the wires are touching each other,
	erly.	other connectors, or any metal parts
		(page 11).
	The volume is set at minimum.	Turn up the volume (page 19).
There’s no sound coming
	The CR-505DAB is muted.	Unmute the CR-505DAB (page 31).
from the speakers?
	A pair of headphones is connected.	Turn down the volume, then disconnect the
		headphones (page 19).
	The wrong input source is selected.	Check the input source setting (page 19).
	A connecting cable may be damaged.	Check your connecting cables for signs of
		damage and replace as necessary.
		Check the speaker connections and make sure
Sound is coming from only	The other speaker’s cable is not connected	that none of the wires are touching each other,
one speaker?	properly.	other connectors, or any metal parts
		(page 11).
	The batteries are used.	Replace with new batteries (page 7).
	The batteries are installed incorrectly.	Check the batteries and correct as necessary
		(page 7).
The remote controller
	You’re not pointing the remote controller at	Point the remote controller at the CR-
doesn’t work?	the CR-505DAB’s remote sensor.	505DAB’s remote sensor (page 7).
	A strong light source is interfering with the	Make sure that the CR-505DAB is not sub-
		jected to direct sunshine or inverter-type fluo-
	CR-505DAB’s remote sensor.
		rescent lights. Relocate if necessary.
AM reception is hindered		Relocate your AM antenna.
by a buzzing noise, espe-	Interference caused by electrical equip-
cially at night or with weak	ment, including fluorescent lights.	Install an outdoor AM antenna (page 13).
signals?
		Move the AM loop antenna as far away as
AM reception is hindered	Interference caused by your TV.	possible from your TV.
by a high-pitched noise?		Move the CR-505DAB as far away as possi-
		ble from your TV.
		Install an outdoor antenna as far away as pos-
	Interference is being caused by fluorescent	sible from nearby roads.
Reception is hindered by a
		Move your antenna as far away as possible
	lights being turned on or off, or by the igni-
crackling noise?		from fluorescent lights.
	tion systems of passing cars.
		Adjust the position or direction of your out-
		door antenna.
FM reception and stereo	Tall buildings, mountains, or hills are caus-
separation are poor even	ing wave reflections that interfere with the	Try an FM antenna with better directionality.
though the Tuning and	main signal.
“ST” (FM stereo) indica-
	The station’s signal is too strong.	Try an indoor FM antenna.
tors are shown.

37