Onkyo CR-505DAB instruction manual Abnormal Behavior, Restoring the Default Settings

Troubleshooting—Continued

	Trouble		Possible Cause		Remedy
		The CR-505DAB was already on at the		Set the CR-505DAB to Standby (page 33).
				The CR-505DAB must be in Standby mode,
		specified ON time.
				otherwise the timed task will not work.
		The	-connected cassette tape deck or	You must set the recording devices to standby
The timer didn’t work?		MD recorder had not been in standby mode.		mode too.
		The specified ON time coincided, or over-		Check the timer settings and correct as neces-
		lapped the ON time of another timer.		sary (page 34).
		The CR-505DAB is only connected digi-		To make recordings with		-connected MD
				recorder, connect the recorder’s analog inputs
		tally to the MD recorder.
				to the CR-505DAB’s analog outputs.
		While a timed recording task is in progress,		To hear what’s being recorded, press the
No sound is output when a				[MUTING] button to cancel the Mute func-
		the output of the CR-505DAB is muted.
timed playback or record-				tion. Press it again to mute the CR-505DAB.
ing task starts?		For timed playback, the volume is deter-		Set the volume to a suitable level (page 19).
		mined by the [VOLUME] control.
		There’s no RCA/phono analog audio con-		To use	you must make an analog audio
	doesn’t work.			connection (RCA/phono) between CR-
		nection.		505DAB and your Onkyo components even if
				they are connected digitally.
Standby indicator flashes.		The protection circuit may be activated.		Make sure not to short-circuit the positive and
				negative speaker wires.

Abnormal Behavior

The CR-505DAB contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Restoring the Default Settings

To reset the CR-505DAB to its factory defaults, turn it off and unplug the power cord. Then press and hold the [STANDBY/ ON] button on the CR-505DAB, and plug in the power cord.

39