Onkyo D0901-2, DS-A3, 29344880A Setting the TV System European, Model only, Other Functions

Using the RI Dock—Continued

Setting the TV System (European			• Timer Play
model only)			You can use your amp’s Timer function to turn
			on your amp and iPod and start playback at a
While the OSD mode is set to On, you can set
			specified time.
the RI Dock’s video output to PAL or NTSC.			• Using Your Amp’s Remote Controller
If the onscreen display looks distorted on your
			You can use your amp’s remote controller to
TV, try changing the TV system.			control basic iPod functions (see page 16).
• While pressing and holding down the			Operating Notes:
	[SETUP] button, press the VOLUME Up [ ]
	button for more than 3 seconds to select		• The RI Dock must be connected to your
	NTSC, or press the VOLUME Down [ ] but-		amp with both an		cable and an audio
	ton for more than 3 seconds to select PAL.		cable to use the	functions.
			• If your amp doesn’t support the System
			On, System Off, Auto Power On, and
Other Functions
			Direct Change functions, you’ll need to
■		Functions	turn your amp on and off and select the
Depending on your amp and generation of			input source manually.
			• Before you select another input source,
iPod, you may also be able to use the following
functions.			stop iPod playback to prevent your amp
			from selecting the iPod input source by
Note:			mistake.
• Your amp may take several seconds to			• If any accessories are connected to your
	startup, so you might not hear the first		iPod, your amp may not be able to select
	few seconds of the first song/video.		the input source properly.
			• While your iPod is in the RI Dock, its vol-
•	System On Function		ume control has no effect. If you adjust
When you turn on your amp, the iPod turns on			your iPod’s volume control while it’s in the
as well. With some amps, you may need to			RI Dock, make sure it’s not set too high
press the [ON] button on your amp’s remote			before you reconnect your headphones.
controller’s twice to turn on the other compo-
nents in your system.
•	System Off Function

When you turn off your amp, the iPod turns off as well.

• Auto Power On Function*

If you start iPod playback while your amp is on Standby, your amp will automatically turn on and select your iPod as the input source. Then, your iPod will start playback.

• Direct Change Function*

If you start iPod playback while listening to another input source, your amp will automati- cally select your iPod as the input source.

*If you use your iPod’s controls to start an iPod slideshow or video, these functions will not work, so use the remote con- troller instead.

14