Onkyo DS-A3 Setting the Remote Controller’s ID, Using Your iPod’s Alarm Clock, ID #1 PLAYLIST Up

Using the RI Dock—Continued

■Using Your iPod’s Alarm Clock

You can use your iPod’s Alarm Clock function to automatically turn on your iPod and amp at a specified time. Your amp’s input source will automatically be set to the input to which your iPod is connected.

Setting the Remote Controller’s ID

If you cannot adjust the volume of your Onkyo component with the DS-A3’s remote controller, try changing its remote control ID. The default setting is #1.

Some Onkyo components are set to ID #2 or #3.

Notes:	• While pressing and holding down the
• This function only works when the OSD	[SETUP] button, press one of the following
mode is set to Off.	buttons for more than 3 seconds to set the
• To use this function, your iPod must be in	ID:
the RI Dock, and the RI Dock must be con-	ID #1: PLAYLIST Up [	] button
nected to your amp with both an	ID #2: ALBUM Up [ ] button
cable and an audio cable.	ID #3: PLAYLIST Down [ ] button
• When you use this function, be sure to set	ID #4: ALBUM Down [	] button
your amp’s volume control to a suitable
level.

• Your amp may take several seconds to startup, so you might not hear the first few seconds of the first song/video.

■ Charging Your iPod’s Battery

The RI Dock charges your iPod’s battery while your iPod is in the RI Dock.

Notes:

•To charge your iPod battery, the AC adapter must be plugged into a suitable wall outlet and connected to the RI Dock’s DC IN jack.

•See your iPod’s instruction manual for more information on battery charging.

15