Onkyo DV-CP704S Setting the Hdmi, Press the Resolution button, To turn Hdmi on or off

Advanced Playback—Continued

RESOLUTION

Setting the HDMI

This section explains how to turn HDMI on and off and change the video resolution when your TV or projector is connected to the HDMI OUT.

1	Press the [RESOLUTION] button
	to turn HDMI on or off.
	If HDMI is off, “HDMI OFF” appears
	on the display the first time the button is
	pressed. Press the button again while
	“HDMI OFF” is displayed to turn on
	HDMI.
	To turn off HDMI, press and hold the
	[RESOLUTION] button.
2	Press the [RESOLUTION] button

Remote controller on the remote controller repeat- edly to change the HDMI resolu-

tion.

The fist button press displays the cur- rent resolution onscreen. Press the but- ton again while the resolution is displayed to change the setting. The DV-CP704 supports the following res- olutions:

Auto:

The resolution is automatically set to the native resolution of the TV connected to the HDMI OUT. Depending on the resolution set- ting on the TV, the DV-CP704 may not output video from its analog video outputs.

480p(480p/576p):

The setting displayed depends on the country in which you purchased the DV-CP704.

720 ⋅ 480p 60Hz or 720 ⋅ 576p 50Hz

Also output by the DV-CP704’s analog video outputs.

720p:

1280 ⋅ 720p 50/60Hz

Not output by the DV-CP704’s ana- log video outputs.

1080i:

1920 ⋅ 1080i 50/60Hz

Not output by the DV-CP704’s ana- log video outputs.

Tip:

These settings can also be changed by using the onscreen setup menus (see page 44).

Notes:

•Depending on your setup, you may find that there’s no picture when you turn on HDMI. In this case, you need to check the HDMI resolution setting and your TV’s settings. If there is no picture, press the [RESO- LUTION] button repeatedly until the picture reap- pears.

•While HDMI is on and the resolution is set to 480p (480p/576p), the component video output is fixed at progressive video.

39