Useful Functions

DISPLAY

チ

1

2

3

REPEAT

4

5

6

MEMORY

7

8

9

CLEAR

+10

0

NEXT

TIME EDIT

SELECTION

PEAK SEARCH

A－极

圠殢濉扳

 

A–B

PEAK SEARCH

REMOTE CONTROLLER

RC-402C

1

Remote controller

PEAK SEARCH

Flashes

Lights

 

 

 

 

 

PEAK SEARCH

 

 

 

PEAK SEARCH

 

2

Remote controller

A－极

3

Remote controller

4

Remote controller

Peak search

This function searches for the peak sound level on the disc.

When using the memory mode, press the MEMORY button to return to normal mode.

1. Press the PEAK SEARCH button.

•The CD player checks the disc for the highest sound level. The PEAK SEARCH indicator will flash during this operation. When the search is complete, the indicator will light.

2. Press the A-B button.

“P” appears in the memory channel display area and flashes.

3. Press the PLAY button.

• The section of the disc with the highest sound level will be played repeatedly for 6 seconds. Refer to this level when recording the disc onto a cassette tape.

4. Press the STOP button.

The CD player stops.

• This level is stored until the

OPEN/CLOSE button is pressed or the power is turned off. To repeat the 6-seconds playback of the peak level, follow steps 2, 3, and 4 when the CD player is stopped.

• Pressing the PEAK SEARCH button will turn off the PEAK SEARCH indicator and the level will be cleared from the memory.

• Pressing the A-B button after pressing the PLAY button will start the block repeat operation.

Note:

Depending on the disc playing, memorizing of a level which is not the maximum audible level could occur. This is due to the CD player’s microprocessor memorizing inaccurate information because of flaws in the disc itself, or recording conditions. Under such circumstances, the recording level for the cassette tape may be very low, or else distortion or similar symptoms could arise on account of excessively high signal levels. To avoid this, be sure to reset the recording level of the cassette deck if such symptoms occur.

13