System connections

Connecting other components
•Do not plug in the AC power cord until all other connections have been made.

•On each pair of input or output jacks, the jack marked R corresponds to the right channel, and the jack marked L to the left channel. Refer to the amplifier’s instruction manual for further information on connections.

•Avoid bundling the audio connection cables with the power cord or speaker cables. Doing so may degrade sound reproduction.

•Insert the plugs and connectors securely. Remember that improper connection can result in noise, poor performance, or dam- age to the equipment.

鄞 ㎈

 

 

Terminal protection caps are attached to the DIGITAL OUTPUT

 

 

 

terminals. Remove the cap for the terminal you wish to use when

 

鄷

㎈

connecting the DX-7222 to digital equipment. Replace the caps

 

if you are not using the DIGITAL OUTPUT terminals.

 

 

 

 

 

 

 

ANALOG

DIGITALDIGITALREMOTE

 

 

 

 

OUTPUT

OUTPUT OUTPUT CONTROL

 

 

 

 

 

OPTICAL 1 OPTICAL 2

麯襚≳忬奵囦゛爗靸Ǚ

 

 

 

 

 

 

 

 

L

 

褵㚖汹鼛ニ 娗例ヰゾ

葅◊迵皡

Ą謜叠

 

 

 

ķ愹麄睽

℮圥゜淎晎㫖憄辤‘葒�

℮坮殠໐搥鷀鞭╱牐丒℮2扳

 

 

 

 

姈〓啡゜6霢

麂゛ǘ゜氻℮Ǚ

R

 

 

 

3

 

Audio connection cable

 

Connecting an Onkyo product

 

 

 

with

connectors enables you

 

 

 

to use the System function.

 

 

 

 

4 To AC outlet

 

cable

Optical fiber cable

 

 

 

 

 

�

 

1

2

(not included)

2

L R

 

 

 

 

(REC)

jackDIGITAL IN

DIGITAL IN

Amplifier without

MD player, DAT, etc.

Amplifier, Tuner amplifier

digital inputs

with digital inputs

with digital inputs

A Connection with the amplifier

Connect the DX-7222 to the CD jacks of your amplifier.

B Connection via the digital output terminal (DIGITAL
OUTPUT)

Connection to digital equipment, such as an MD recorder or DAT.

Use an optical cable to connect this unit to the digital input terminal of an MD recorder or DAT in order to make digital recordings. The optical cable should have connectors which fit into the digital terminals.

C Connections for remote control

ONKYO

When the DX-7222 is connected to an amplifier with the Onkyo

 

jack, pressing the CD operation button on the amplifier’s

 

remote controller enables you to operate the CD player.

 

Note:

 

 

D Connecting the AC power cord and turning the

• The upper and lower

remote control jacks have the

power on

same function.

 

 

 

• Remote control operation is not possible when only the

1. Insert the AC power cord into a wall outlet.

remote control cable is connected – the audio cables must

2. Press the POWER ON/OFF button.

also be connected.

 

The display will light.

• An

cable equipped with a 1/8" (3.5mm) diameter min-

Note:

iature two-conductor phone plug is included with the DX-

To insert the AC power cord into an AC outlet on the rear panel of

7222 and with every tuner, compact disc player or cassette

tape deck with the

symbol.

another component, use the UNSWITCHED outlet.

6