Before operating this unit

ANALOG

DIGITAL

DIGITAL

REMOTE

OUTPUT

OUTPUT

OUTPUT

CONTROL

 

OPTICAL 1

OPTICAL 2

COMPACT DISC PLAYER

L

MODEL NO. DX-7222

WARNING

AVIS

 

RATING:

RISK OF ELECTRIC SHOCK

RISQUE DE CHOC ELECTRIQUE

 

 

DO NOT OPEN

NE PAS OUVRIR

R

220-230V 120V

VOLTAGE SELECTOR

VOLTAGE SELECTOR

220-230V

120V

Setting the Voltage selector (Worldwide models only)

Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit.

1.Determine the proper voltage for your area: 220-230 V or 120 V.

2.If the preset voltage is not correct for your area, insert a screw- driver into the groove in the switch. Slide the switch all the way to the right (120 V) or to the left (220-230 V), whichever is appropriate.

1

2

3

DX-7222Remote control sensor

30˚

30˚

approx. 5 m

 

(16 feet)

Installing the remote controller batteries

1.Remove the battery compartment cover by opening it as shown in the illustration.

2.Insert two AA (R6- or UM-3)-size batteries into the battery compart- ment. Carefully follow the polarity diagram (positive (+) and nega- tive (–) symbols) inside the battery compartment.

3.After batteries are installed and seated correctly, replace the com- partment cover.

Notes

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.

•Remove dead batteries immediately to avoid damage from cor- rosion. If the remote controller doesn’t operate smoothly, replace both the batteries at the same time.

•The life of the batteries supplied is about six months but this will vary depending on usage.

Using the remote controller

Point the remote controller toward the remote control sensor.

Notes

•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.

•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.

•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.

•Make sure the audio rack doors do not have colored glass. Plac- ing the unit behind such doors may prevent proper remote con- troller operation.

•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

5