PrecautionsFeatures
You can find the serial number on the rear panel of this unit. In case of warranty claim, please report this number.
2. Recording CopyrightRecording of copyrighted material for other than personal use is illegal without permission of the copyright holder.
3.PowerWARNINGBEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz) written on the rear panel.
Worldwide models are equipped with a voltage selector to conform to local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit.
4. Do not touch this unit with wet handsDo not handle this unit or power cord when your hands are wet or damp. If water or any other liquid enters the case, take this unit to an authorized service center for inspection.
5. Location of this unitPlace this unit in a
Take special care to provide plenty of ventilation on all sides of this unit especially when it is placed in an audio rack. If ventilation is blocked, this unit may overheat and malfunction.
Do not expose this unit to direct sunlight or heating units as this unit’s internal temperature may rise and shorten the life of the pickup.
Avoid damp and dusty places and places directly affected by vibrations from the speakers. In particular, avoid placing the unit on or above one of the speakers.
Be sure this unit is placed in a horizontal position. Never place it on its side or on a slanted surface as it may malfunction.
Do not place near tuners or TV sets.
If placed next to a TV or tuner, it may cause reception interference resulting in some noise in the TV or tuner output.
6. CareFrom time to time you should wipe the front and rear panels and the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a weak solution of mild detergent and water, wring it out dry, and wipe off the dirt. Following this, dry immediately with a clean cloth.
Do not use rough material, thinners, alcohol or other chemical solvents or cloths since these could damage the finish or remove the panel lettering.
7. Points to rememberIf this unit is brought from a cold environment to a warm one or is in a cold room that is quickly heated, condensation may form on the pickup, preventing proper operation. In this case, remove the disc and leave the power ON for about one hour to remove the con- densation.
When transporting this unit, be careful not to bump it.
■Time edit (calculates number of tracks that will fit on a cassette) (Remote controller only)
■A convenient feature that lets you easily eliminate tracks you don’t want to hear or record.
■Next selection (Remote controller only)■Five mode repeat function: entire side, single track,This unit does not require memory preservation batteries. A
The memory preservation period after the unit has been turned off varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been turned off. This period is shorter when the unit is exposed to a highly humid cli- mate.
Supplied accessories
Check that the following accessories are supplied with this unit.
DI
SPLAY
|
|
|
|
| 1 |
|
| |
|
|
|
| 4 |
| 2 |
|
|
|
|
|
| 7 | 5 | 3 |
| |
|
| PEAK | +10 | 8 |
| 6 | REPEAT |
|
|
| SEA | 0 | 9 | MEM |
| ||
|
|
| NE |
|
| ORY |
| |
|
|
| RCH |
| CLEAR |
|
| |
Audio connection cable ⋅1 | REMOTE |
| A-极 | SELECTIOXTN |
|
|
| |
|
| 叠䐈桰泂泂椗扳 | TIME | EDIT |
|
| ||
| CONTROLLER | RC- |
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
| 402C |
|
|
|
|
|
| Remote controller ⋅ 1 | ⋅ 2 | ||||||
cable ⋅ 1 | Batteries (size AA, R6 or | |||||||
|
|
|
|
|
|
|
|
4