Onkyo HT-R420 Precautions, For U.S. models, For Canadian models, Modèle pour les Canadien, Power

Precautions

For U.S. models

Note to CATV system installer:

This reminder is provided to call the CATV system installerÕs attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

FCC information for user

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the userÕs authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

¥Reorient or relocate the receiving antenna.

¥Increase the separation between the equipment and receiver.

¥Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

¥Consult the dealer or an experienced radio/TV technician for help.

For Canadian models

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMƒRIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU CANADA.

Sur les mod•les dont la fiche est polarisŽe:

ATTENTION: POUR ƒVITER LES CHOCS ƒLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUÕAU FOND.

1.Recording CopyrightÑUnless itÕs for personal use only, recording copyrighted material is illegal without permission of the copyright holder.

2.AC FuseÑThe AC fuse inside the HT-R420 is not user- serviceable. If you cannot turn on the HT-R420, contact your Onkyo dealer.

3.CareÑOccasionally you should dust the HT-R420 all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the HT-R420 immediately afterwards with a clean cloth. DonÕt use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the HT-R420Õs rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The Worldwide model has a voltage selector for compatibility with power systems around the world. Before you plug in this model, make sure that the voltage selector is set to the correct voltage for your area.

Setting the [STANDBY/ON] switch to STANDBY does not fully shutdown the HT-R420. If you do not intend to use the HT-R420 for an extended period, remove the power cord from the AC outlet.

3