Onkyo appendix Using the RC-518M, Point the remote controller at the HT-R420

Using the remote controller with your other AV components

Using the RC-518M

		(RC-518M/RC-479S)
If you need to enter the manufacturerÕs code	for your AV
		DVD mode
component into the remote controller, see page 33.

1. Point the remote controller at the HT-R420 and

use the input selector buttons to select an

input source for the HT-R420.

3.

2.	Use the remote controller’s mode buttons (i.e.,
	VCR, TV, CABLE/SAT, CD/DVD, or RCVR/TAPE)
	to select a remote controller mode.
	(You donÕt have to point the remote controller at anything for
	this step.)
3.	Use the remote controller’s Power	button to
	turn on the AV component.
	Remember, if your AV component is connected to the HT-

4. DVD

operation

buttons

2.CD/DVD

The RC-518M remote controller is shown here.

(DVD on the RC-479S)

R420 via z, point the remote controller at the

HT-R420. If not, point the remote controller at the AV

component.

(A cassette recorder canÕt be turned on or off from the remote

controller. You must use its POWER switch.)

4. Use the buttons as explained below.

In the following illustrations, buttons that control the HT-R420

regardless of which mode is selected are shaded. When you

want to control the HT-R420 fully, press the RCVR/TAPE

button, then you can use all the buttons that apply to the HT-

R420.

Using the RC-479S

1.Point the remote controller at the HT-R420 and use the input selector button to select an input source for the HT-R420.

2.Use the remote controller’s mode buttons (i.e., DVD, CD, RCVR/TAPE) to select a remote controller mode.

(You donÕt have to point the remote controller at anything for this step.)

3.Use the remote controller’s Power button to turn on the AV component. Point the remote controller at the HT-R420.

(A cassette recorder canÕt be turned on or off from the remote controller. You must use its POWER switch.)

4.Use the buttons as explained below.

In the following illustrations, buttons that control the HT-R420 regardless of which mode is selected are shaded. When you want to control the HT-R420 fully, press the RCVR/TAPE button, then you can use all the buttons that apply to the HT- R420.

1. DVD input selector

RC-518M:

You must enter the appropriate manufacturer’s code for your DVD player (see page 33).

: Power On/Off.

£: Starts playback of DVD.

7 :Stops playback.

¡: Searches the disc in the forward direction.

1 : Searches the disc in the reverse direction.

8 :Lets playback pause temporarily or advances the disc frame by frame.

¢: Starts playback from the beginning of the next chapter/track.

4 : Starts playback from the beginning of the current chapter/track.

DISC : This button is valid when the DVD changer is used and selects the disc to be played.

1Ð9, +10, 0 : Use to enter numeric values.

TOP MENU : Displays the top menu of each DVD disc.

MENU : Displays a menu recorded in the DVD disc.

RETURN : Returns to the previous menu.

SETUP : Displays the setup menu.

5/∞/2/3 : Selects an item in a menu.

ENT : Enters the selection in memory.

Note

RC-518M:

Since you can only enter a CD code or DVD code for the CD/DVD button, you can use CD mode or DVD mode, but not both.

35