Using the Remote Control

This section explains how to operate the camera using the optional remote control units, DR-3 and DR-4 (available in the near future).

Important

Note

Note

The remote control receiver is located on the front of the camera. Operate the remote control unit by pointing it at the remote control receiver.

For instructions on replacing the batteries and maintaining the remote control unit, refer to the accompanying manual.

Some procedures differ when performed on the remote control unit and on the camera itself. Follow the instructions below to use the remote control unit.

Using the DR-4 Remote Control

A Set the mode dial on the camera to a recording mode ( , , or ) and

press the

 

button to select the

 

recording destination.

B Decide the composition of the picture and press the RELEASE button on the remote control unit.

Press

to make the subject larger, and

press

to make the subject smaller.

In

(Still Picture) mode

The self-timer LED will light and recording will start after about 2 seconds.

In (Text) mode

Recording starts as soon as the RELEASE button is pressed.

In (Voice Memo) or (Motion Picture) mode

Recording of the image and/or voice memo starts when the RELEASE button is pressed. Recording stops when the button is pressed again.

120

Page 122
Image 122
Ricoh CAMERA RDC-i500 Using the Remote Control, Using the DR-4 Remote Control, Still Picture mode, Text mode