Ricoh CAMERA RDC-i500 operation manual Error Messages, Error Message Remedy

Error Messages

If an error message is displayed on the LCD monitor or LCD panel, follow the procedures below.

Error Message	Remedy
System error occurs	Turn the power off and on.
Unable to change memory	Storage memory can not be switched due to some reason. Check
	content of storage memory or format storage memory.
Insufficient memory	Erase unwanted files or format to obtain sufficient memory space.
Change to card	Change the storage memory to card by using	.
Format required	Format of selected storage memory damaged. Format storage
	memory.
Format internal memory	Internal memory damaged. Format it by pressing shutter release
	button.
Card is unavailable	Card damaged. Format.
Format error	Format again. If formatting is not completed, memory error
	occurs. Avoid using the storage memory.
UNMATCHED FILE	Unplayable file was selected.
No file	No recorded files in specified folder. Change folder or select
	storage memory that contains files.
Insufficient memory. Continue copy?	Exceeded memory capacity. Perform one of following and copy
	again:
	• Delete unnecessary copy source,
	• Delete unnecessary files in destination, or
	• Format storage memory.
File number over. Cannot save.	File number exceeded limit. Delete unnecessary files or use
	another memory card.
Exceeded DPOF limit. Set up to 999.	Number of index print or number of specified print exceeded limit.
	Reset DPOF settings of some files.
Failed to create DPOF files	DPOF settings cannot be saved. Delete unnecessary files before
	repeating operation. If message still appears, memory may be
	damaged. Make a backup file of files saved in memory and
	format memory.
Failed to read DPOF files	DPOF settings are unreadable. Reset all DPOF settings before
	repeating operation. If message still appears, memory may be
	damaged. Make a backup file of files saved in madia and format
	memory.

Note • If the error message continues to be displayed after the above procedures have been followed, open the terminal cover and press the reset switch (P.6) with the tip of a propelling pencil or similar object. The settings will return to the factory default settings.

If the error message is still displayed, contact the store where purchased or your nearest Ricoh service office.

Appendix

131