Onkyo HT-R690 Connecting the AV Receiver, Connecting Your Speakers, Screw-typespeaker terminals

Connecting the AV Receiver

Connecting Your Speakers

Connecting the Speaker Cables

The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.

Surround		Surround		Center
	right		left

Surround back/	Surround back/	Front right	Front left
Front high	Front high
right	left

Tip

•You can specify whether surround back or front high speakers are connected in the “Speaker Configuration” menu (➔ page 42) or during Audyssey 2EQ® Room Correction and Speaker Setup (➔ page 28).

•The speakers you can connect will differ depending on the speaker system that you have.

■Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of insulation from	1/2" to 5/8" (12 to 15 mm)
the ends of the speaker cables, and twist the bare
wires tightly, as shown. (Supplied speaker cables are
already stripped.)

■Push-type speaker terminals

Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. (Supplied speaker cables are already stripped.)

3/8" to 1/2" (10 to 12 mm)

En

11