Network
After modifying the network settings, you must confirm the changes by executing “Save”.
This section explains how to configure the AV receiver’s network settings manually.
If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV receiver is set to use DHCP to configure itself automatically by default (i.e., DHCP is set to “Enable”). If, however, your router’s DHCP server is disabled (you’re for example using static IP), you’ll need to configure these settings yourself, in which case, a knowledge of Ethernet networking is essential.
What’s DHCP?
DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV receiver, and other devices to automatically configure themselves on a network.
What’s DNS?
The DNS (Domain Name System) translates domain names into IP addresses. For example, when you enter a domain name such as www.onkyousa.com in your Web browser, before accessing the site, your browser uses DNS to translate this into an IP address, in this case 63.148.251.142.
■MAC Address
This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.
■DHCP
`Enable
`Disable
This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.
Note
•If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.
■IP Address
`Class A:
“10.0.0.0” to “10.255.255.255”
`Class B:
“172.16.0.0” to “172.31.255.255”
`Class C:
“192.168.0.0” to “192.168.255.255” Enter a static IP address provided by your ISP. Most routers use Class C IP addresses.
■Subnet Mask
Enter the subnet mask address provided by your ISP (typically 255.255.255.0).
■Gateway
Enter the gateway address provided by your ISP.
■DNS Server
Enter the DNS server address provided by your ISP.
■Proxy URL
To use a Web proxy, enter its URL here.
■Proxy Port
If you’re using a Web proxy, enter a proxy port number here.
■Network Control
`Enable
`Disable
This setting enables or disables control over the network.
Note
•When set to “Enable”, the NET indicator is
■Control Port
`“49152” to “65535”
This is the network port used for control over the network.
Note
•When the “Network Control” setting is set to “Disable”, this setting is cannot be selected.
Firmware Update
See “Firmware Update” for the update procedure
(➔ page 73).
Note
•Perform the firmware update only when such an announcement is posted on the Onkyo web site. Visit the Onkyo web site for the latest information.
•It takes maximum 60 minutes to complete the firmware update.
■Version
Displays the current version of the firmware.
■Receiver
`via NET:
Performs the firmware update via Internet. Check the network connection before updating.
`via USB:
Performs the firmware update from a USB device. These settings allow you to update the AV receiver’s firmware. Do not shutdown the power of the AV receiver while updating.
■Universal Port
`via NET:
Performs the firmware update via Internet. Check the network connection before updating.
`via USB:
Performs the firmware update from a USB device. These settings allow you to update Onkyo dock’s firmware. Do not shutdown the power of the AV receiver while updating.
Note
•This update shall not be performed when no dock is connected to the UNIVERSAL PORT jack.
En
53
