Onkyo HT-R690 Powered Zone, Subwoofer, Front, Center*1, Surround*1, Surround Back*2*3*4*5

Speaker Settings

If you change these settings, you must run Audyssey 2EQ® Room Correction and Speaker Setup again (➔ page 28).

■Powered Zone 2

`No

`Yes:

Zone 2 speakers can be used. (Powered Zone 2 enabled).

Note

•Before you change this setting, turn down the volume.

•When the “Powered Zone 2” setting is set to “Yes”, the surround back or front high speakers cannot be used.

Speaker Configuration

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify “Full Band” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.

Note

•These settings are not available in either of the following cases:

–a pair of headphones is connected.

–the “Audio TV Out” setting is set to “On” (➔ page 52).

–“HDMI Control (RIHD)” is set to “On” (➔ page 51) and you’re listening through your TV speakers.

■Subwoofer

`Yes

`No

■Front

`Full Band

`40Hz to 100Hz, 120Hz, 150Hz, 200Hz

Note

•If the “Subwoofer” setting is set to “No”, the “Front” setting is fixed to “Full Band”.

■Center*1, Surround*1, Surround Back*2*3*4*5

`Full Band

`40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`None

■Front High*1*2*4*6

`Full Band

`40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`None

Note

*1	“Full Band” can be selected only when “Full Band” is
	selected in the “Front” setting.
*2	If the “Surround” setting is set to “None”, this setting cannot
	be selected.
*3	If the “Surround” setting is set to anything other than “Full
	Band”, “Full Band” cannot be selected here.
*4	If the “Powered Zone 2” setting is set to “Yes”, this setting
	cannot be selected.
*5	If anything else than “None” is selected in “Front High”, this
	setting is automatically set to “None”.
*6	If anything else than “None” is selected in “Surround Back”,
	this setting is automatically set to “None”.

■Surround Back Ch

`1ch:

Select if only one surround back speaker L is connected.

`2ch:

Select if two (left and right) surround back speakers are connected.

Note

•If the “Surround Back” Setting is set to “None”, this setting cannot be selected.

■LPF of LFE

(Low-Pass Filter for the LFE Channel)

`80Hz, 90Hz, 100Hz, 120Hz

`Bypass:

Low-Pass Filter is not applied.

With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.

En

42