Onkyo HT-R690 instruction manual 3 4 5 6 7, When you’ve finished making the settings, press, Enter

3

4

5

6

7

8

When you’ve finished making the settings, press

ENTER.

2EQ: Auto Setup

	AUDYSSEY
Powered Zone 2	No
Surround Back/Front High	Surround Back

Perform the “Speaker Setup” according to your speaker configuration:

–Powered Zone 2 (➔ page 42)

–Surround Back/Front High (➔ page 42)

When an optional unit is connected to the UNIVERSAL PORT jack on the AV receiver, the optional unit setting may appear on the speaker setting menu.

Use q/wto select “Audyssey Quick Start” or “Audyssey 2EQ Full Calibration”.

Press ENTER.

Audyssey 2EQ® Room Correction and Speaker Setup starts.

Test tones are played through each speaker as Audyssey 2EQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey 2EQ Room Correction and Speaker Setup, unless you want to cancel the setup.

If you select “Audyssey Quick Start”, you will go to step 8.

Place the setup microphone at the next position, and then press ENTER.

Audyssey 2EQ performs more measurements. This takes a few minutes.

When prompted, repeat step 6.

Use q/wto select an option, and then press

ENTER.

2EQ: Auto Setup
		AUDYSSEY
-- Review Speaker Configuration --
Subwoofer	:	Yes
Front	:	100Hz
Center	:	40Hz
Surround	:	100Hz
Front High	:	None
Surround Back	:	120Hz
Surround Back Ch	:	2ch
Save
Cancel

The options are:

`Save:

Save the calculated settings and exit Audyssey 2EQ Room Correction and Speaker Setup.

`Cancel:

Cancel Audyssey 2EQ Room Correction and

Speaker Setup.

Tip

•You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using e/r.

9 Use q/wto select a target, and use e/rto change the setting.

After the results of Audyssey 2EQ have been saved, the menu will display the “Audyssey” (➔ page 45), “Dynamic EQ” (➔ page 45), “Dynamic Volume” (➔ page 46) settings.

Note

•When “Audyssey Quick Start” has been used for measurement, “Audyssey” cannot be selected.

•These settings are applied to all input selectors.

10 Press ENTER.

11 Disconnect the speaker setup microphone.

Note

•You can cancel Audyssey 2EQ Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.

•Do not connect or disconnect any speakers during Audyssey 2EQ Room Correction and Speaker Setup.

•If the AV receiver is muted, it will be unmuted automatically when Audyssey 2EQ Room Correction and Speaker Setup starts.

•Changes to the room after Audyssey 2EQ Room Correction and Speaker Setup requires you run Audyssey 2EQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed.

En

29