Onkyo HT-RC270 Controlling Other Components, Resetting REMOTE MODE Buttons, Controlling a TV

If you want to control an Onkyo component by pointing the remote controller directly at it, use the following remote control codes:

`32900:

Onkyo Blu-ray Disc player

`32901:

Onkyo HD-DVD player

`70868:

Onkyo MD recorder without u

`71323:

Onkyo CD recorder without u

`82990:

Onkyo Dock without u

Note

•If you connect a cassette tape deck to the TV/CD IN jack, or connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or GAME IN jacks, for uto work properly, you must set the Input Display accordingly (➔ 27).

Controlling Other Components

By pressing REMOTE MODE that’s been programmed with the remote control code for your component, you can control your component as below.

For details on entering a remote control code for other components, see “Entering Remote Control Codes” (➔ 77).

Controlling a TV

TV is preprogrammed with the remote control code for controlling a TV that supports the p*1 (limited to some models). The TV must be able to receive remote control commands via pand be connected to the AV receiver via HDMI. If controlling your TV via

pdoesn’t work very well, program your TV’s remote control code into TV and use the TV remote mode to control your TV.

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote control code.

1 While holding down REMOTE MODE that you want to reset, press and hold down HOME until REMOTE MODE lights (about 3 seconds).

2 Within 30 seconds, press REMOTE MODE again.

REMOTE MODE flashes twice, indicating that the button has been reset.

Each of REMOTE MODE is preprogrammed with a remote control code. When a button is reset, its pre- programmed code is restored.

Note

• The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1 While holding down RECEIVER, press and hold down HOME until RECEIVER lights (about 3 sec- onds).

2 Within 30 seconds, press RECEIVER again.

RECEIVER flashes twice, indicating that the remote controller has been reset.

Controlling a Blu-ray Disc/DVD Player, HD DVD Player or DVD Recorder

BD/DVD is preprogrammed with the remote control code for controlling a component that supports the p*1 (limited to some models). The component must be able to receive remote control commands via pand be connected to the AV receiver via HDMI.

*1 The psupported by the AV receiver is the CEC system control function of the HDMI standard.

En

78