2 Use q/w/e/rto make the desired selection.

Audio*1

`You can change the following settings: “Bass”, “Treble”, “Subwoofer Level”, “Center Level”, “Dynamic EQ”, “Dynamic Volume”, “Late Night”, “Music Optimizer”, “Cinema filter” and “Audio Selector”.

See also:

“Audyssey” (44)

“Using the Audio Settings” (50)

Video*2

`You can change the following settings: “Wide Mode” and “Picture Mode”.

See also:

• “Picture Adjust” (46)

Info*3*4

`You can view the information of the following items: “Audio”, “Video” and “Tuner”.

Input Sel*4*5

`You can select the input source while viewing the information as follows: the name of input selectors, input assignments, and radio informa- tion, and ARC function setting.

Press ENTER to display the current input source, followed by q/wto select the desired input source. Pressing ENTER again switches to the selected input source.

Listening Mode

`You can select the listening modes that are grouped in the following categories: “MOVIE/ TV”, “MUSIC” and “GAME”.

Use q/wto select the category and e/rto select the listening mode. Press ENTER to switch to the selected listening mode.

Note

*1 If Direct listening mode is selected, “Dynamic EQ” and “Dynamic Volume” cannot be selected.

*2 Only when you have selected “Custom” in the “Picture Mode” (46), pressing ENTER allows you to adjust the fol- lowing items; “Brightness”, “Contrast”, “Hue”, and “Satu- ration”. Press RETURN to return to the original Video menu.

*3 Depending on the input source and listening mode, not all channels shown here output the sound.

*4 When you have entered a custom name in “Name Edit” (45), the input source is displayed with that name. But even if not, the component name may be displayed if the AV receiver receives it via HDMI connection (19).

*5 For the PORT input selector, the name of Universal Port Option Dock will be displayed.

Changing the Input Display

When you connect an u-capable Onkyo component, you must configure the input display so that ucan work properly.

This setting can be done only from the front panel.

1 Press TV/CD, GAME or VCR/DVR so that “TV/ CD”, “GAME” or “VCR/DVR” appears on the display.

2 Press and hold down TV/CD, GAME or VCR/DVR (about 3 seconds) to change the input display.

Repeat this step to select “MD”, “CDR”, “DOCK” or “TAPE”.

For the TV/CD input selector, the input display changes in this order:

TV/CD MD CDR

TAPE

DOCK

 

 

 

 

 

 

For the GAME input selector, the setting changes in this order:

GAME DOCK

For the VCR/DVR input selector, the setting changes in this order:

VCR/DVR DOCK

Note

DOCK can be selected for the TV/CD, GAME or VCR/DVR input selector, but not at the same time.

Enter the appropriate remote control code before using the remote controller for the first time (60).

Using Headphones

Connect a pair of stereo headphones with a stan- dard plug (1/4 inch or 6.3 mm) to the PHONES jack.

Note

Always turn down the volume before connecting your head- phones.

While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Powered Zone 2 speakers are not turned off.)

When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono or Direct.

Only the Stereo, Direct and Mono listening modes can be used

with headphones.

En

27

Page 27
Image 27
Onkyo HT-S7300 instruction manual Changing the Input Display, Using Headphones